TR-8S per-step automatization Problem

Forum for Aira
Post Reply
kingofflakess
Posts: 3
Joined: 18:21, 15 January 2023

TR-8S per-step automatization Problem

Post by kingofflakess »

Hello there. I asked this question before but I didn't get the answer :((

I have a problem recording "motion” (aka automatization) using per step method (''entering a value at a specified step" method from TR-8S owner's manual page 11, see screenshot).
Please watch and listen to short video that I attached.

For example I have 4 snare drum hits in pattern. These hits have Decay=50 by default. so I decide to utilise Decay=05 on 3rd hit. After that, as the loop keep playing, ALL hits after 3rd hit will be played back AS IF their Decay was =05 (athough, there is no recorded "motion" on following steps)
At the same time, i can manually (or tweeking knobs while Motion [rec] button is lit) record Decay=50(or any desired number) for all other steps , and now playback is ok, all "motions" are working...., but its not how it suppose to work, right? All no-motion steps that are played after steps with motion, seems to "pick up" last automated value.

I have this problem recording Decay, Tune ant Ctrl controls but surprisingly it works properly with Velocity changings - velocity can be easily modified per step-ly.

It seems to me that it is some software problems so I updated tr-8s to ver 2.51 (i bought it with ver 2.0) but it didnt solve the problem.

Please help, thanks
Attachments
screenshot.png
screenshot.png (1.69 MiB) Viewed 683 times
video 1.mp4
(6.57 MiB) Downloaded 58 times
Post Reply