Need help about sending Sysex data

[Niarf]

Hello allz,

I wish to send Rhythm Pattern changes with a FCB1010 midi floorpedal board.

In the Midi Implementation manual, we can acheive this by sending sysex only. So I use Bome's Midi translator to send a sysex string I have created, but I'm not sure it's ok because it doesn't work =))

Here are my settings :

FCB1010 is connected on the PC with a midi usb interface called USB2 Midi. An USB cable gose to the FA06.

I use switch 1 on the FCB to send the following sysex string :

Code: Select all

String : F0    41     10  00 00 77   12     18 00            50 30             01                      67    F7
 
Desc : Sysex Vendor DevicID Model DataSend StudioSetCtrl Rhythm Pattern Number Data (Verse 1)) CheckSum EOX

Is that correct ?

The ports settings in Bome's seems to be correct because when I press the FCB1010, the FA06 stops the screensaver =)

Thanks in advance for help =)

[Candy]

Can you make rhythm pattern changes manualy and send it to a sequencer in the pc? There you normaly can see the correct sysex-datas, which were recorded

[Niarf]

Thanks for the tip, but the sysex is not transmitted, even if I can see edit datas...