Page 1 of 1
Sampling E/A guitar
Posted: 14:55, 9 September 2005
by modroncube
Hi !
I've just bought a new E/A guitar (Yamaha APX) and I want to sample it. But I get a poor level (less than 0 db). And if I changed gain, I get nothing but a deep breathing...
Does anyone sample guitar and have advice to share ?
Re: Sampling E/A guitar
Posted: 16:04, 9 September 2005
by Quinnx.
You need to changed the MIX IN to Microphone, have you tried this?
Results not Excuses
MSN:
fantom01@hotmail.com
Get optimised: Rev 9.1
http://knightspawn.fws1.com/woodhazel_f ... ilesys.htm
have a listen to
http://forum.fantomized.info/?action=sh ... ge=1#61560
QuinnX universal tranlator below:-
(lets not be misunderstood)
!!!!!! Emphasis not anger
!!?? Confusion or Stupidity
ABC are you getting the point
&*$% Anger (but rarely seen)
Fantom-X6 with Audio Track Expansion (OS 2.0)
Windows 2000
Intel P4 2g
512mb
Re: Sampling E/A guitar
Posted: 22:49, 9 September 2005
by modroncube
Yes I did.
And I obtained a deeper breathing !
Re: Sampling E/A guitar
Posted: 11:02, 10 September 2005
by nsheldon
How are you connecting the guitar to the Fantom? I've connected my electric guitar via a standard 1/4 inch phono cable from the guitar output jack to the AUDIO INPUT (Left) jack on the Fantom-X and it worked fine. Ensure your cable is working (by plugging it into an amp) and that the volume on the pick-ups on the guitar are turned up.
Regards,
Nathan Sheldon
http://www.nathansheldon.com/
Re: Sampling E/A guitar
Posted: 08:51, 27 October 2005
by modroncube
Thanks for your answer,
I tryed my E/A guitar and a friend of mine an electric guitar as well. Actually there is an audible input signal, which - alas ! - contains much breath (especially with "Microphone" preset) when you raise input gain or volume.
This apparently comes from the inputs, when the input signal is low. I've got no problem with "Line in" presets when I plug another synth in input, in which case input signal is louder.
Does anyone know how to have a better signal level for a guitar ?
Re: Sampling E/A guitar
Posted: 16:04, 27 October 2005
by dboulden
This should work fine. I've used both electric guitar and semi-acoustic Mandolin though the Fantom's input. If you are still not getting enough signal, then run the guitar though an FX pedal, stomp box or preamp first then plug that into the Fantom's input. If you don't have a pedal, then this cheap little marvel will sort you out for this purpose:
http://www.behringer.com/PB100/index.cfm?lang=ENG
or for a little more money there are these options:
http://www.behringer.com/ADI21/index.cfm?lang=ENG
http://www.behringer.com/X-V-AMP/index.cfm?lang=ENG (I have one of these)

)
Dave
http://www.drstudio.demon.co.uk/
"Musicians fall into three categories: those with a physical block, those with a mental block and those with a wooden block". Unfortunately, I'm in the 1st category!
Re: Sampling E/A guitar
Posted: 16:58, 27 October 2005
by modroncube
Thanks for your good advice. Actually electric guitar signal is more audible than the E/A guitar signal. Well I may try a preamp booster or something.
Re: Sampling E/A guitar
Posted: 14:08, 1 November 2005
by rogerp1
I had a bit of trouble simlar to this with my takemine A/E.
Then I realised I hadnt changed the battery for 5 years.
Once I put the new battery in it was considerably louder (DOH!!)
I obviously kicked myself but it had me stumped for a couple of days
Re: Sampling E/A guitar
Posted: 20:26, 3 November 2005
by The Box Drone
Yeah, i was just going to mention the battery. Ours (a takemine too actually) just died, and it took me a few to figure out what was going on...
__________________________________________
"Real musicans don't need expensive equipment to create... a true artist will make music with anything that is around them." ~ Mom
Pearls of wisdom, no mistake, but I bought a Fantom-Xa anyways
