Patch and performance

[Manchoa]

Hi and sorry, if this has been here before.

I read the FAQ and did not understand the tips to have same effect settings in Patch and performance mode. Maybe its my bad english.

In FAQ there is: "How do I make a patch in a performance sound the same as when I play it in patch mode?
When you assign a patch to a performance part, it's effects settings are not loaded by default - instead, performance's effects settings are used. To make the performance load the effects settings from that patch:

See which part number you assigned this patch to
Press [EFFECTS]
Press F1 [Routing]
Route this patch to an MFX unit not occupied by other parts
Set the MFX SRC parameter for the corresponding MFX unit to the part number of this patch
For example, if you have a patch on part 3 and you routed it to MFX 2, you need to set MFX 2 SRC to part 3. To load chorus and/or reverb settings as well, use the CHO SRC and REV SRC parameters in the same way"

Can someone explain this to me step by step (dumbuser way) :-)

thanks