Roland Clan Forums

[RPS mixer] feature mentioned in the manual does not work on my machine (OS 1.03).

as i switch between [RPS mixer] fader assignments the faders do go to the position written in an RPS set.

BUT

changing any of the parameters available in the [RPS mixer] mode does not affect the sound of RPS parts.

e.g. i can lower all 8 volume faders to zero with [PART ASSIGN] being switched off but RPS parts 1-8 still play at their default volume.

in other words RPS parts do not react to fader operations in [RPS mixer] as it is described in the manual.

could someone please check this on other machine?

thanks in advance!

I´ve got these problem with some rps but not with all,i haven´the last os...

i tried writing my own RPS set, but the [RPS mixer] behavior is the same - no response to faders.

please check this, mates.

i'm really concerned whether its an OS bug or just my machine quirk.

OS1.03

thanks.

I made my own rps sets and i have problems sometimes with the volume,tone,pan of the rps...But not always,only few times.I think that is a problem with the lenght of the phrases.The new value only do your job at the start of the phrase,if you are in the midlle of the sequence you must wait to the start ...Excuse my english is so bad!!!!I´m spanish......Thanx

in my case i have no reaction to faders ever, be it a start of the phrase, whatever


Arievilo >> my english is so bad!

i can understand you, that's the main thgin 8)
i'm not a native speaker either

if i stop the pattern and let run the rps the volume,pan...works find...try it.

Arievilo: thanks comrade

your method did not work as well %(

Upsss!!!!!Maybe you have a bug!!!!!Sorry....

Hi

In RPS mixer press and hold (Part level) button ... now light of (part select mute) are dark.Hold (Part level) button + All (Part select mute) button.

Regards :-)