Juno 6 VCF issue

Forum for JUNO, JUPITER and JX synthesizers from 1980's
Post Reply
auto64
Posts: 1
Joined: 22:27, 26 September 2015

Juno 6 VCF issue

Post by auto64 »

Just wanting to get your thoughts..

I have a Juno 6 where the VCF sliders play back something that sounds like a random highspeed LFO whenever they are moved.. once you stop moving it, its back to normal..

You reckon this is a filter chip failing?
rcraven
Posts: 632
Joined: 14:36, 9 September 2007
Location: Melbourne Australia

Re: Juno 6 VCF issue

Post by rcraven »

Hi
this is likely to be the wiper on the slider lifting as it goes over a bit of dirt.
This causes random contact with the slider carbon track.

Move the control rapidly back and forth to try and clean it.
If you are felling brave, you might like to spray a little electronic contact cleaner in the slot and then work it again.
This usually does the trick.

All the best
Royce
Post Reply