MC 808 + BCR2000

Forum for MC-808
Post Reply
David MC808
Posts: 1
Joined: 09:55, 23 August 2010

MC 808 + BCR2000

Post by David MC808 »

The connection between the midi-controller and the mc-808 seems to work, i can configure the bcr like a want. I have now 8 channels with volume and some effects i can adjust on the fly without switching part select on my mc. Which was my goal.
On the other hand the problem is that the mc doesnt send midi signal on switching pattern, so the bcr doesnt recieve the 'default' values.

litte example:

pattern1:
mc : volume channel 1: 50%
bcr: volume channel1: 50%

Pattern2:
mc : volume channel 1: 100%
bcr: volume channel1: 50%

when switching to pattern2 the volume of the bcr doesnt adjust to the default value but stays on the previous value. From the moment i adjust the knob on the bcr the volume goes from 50 to 100 and goes then to the desired value.

I have a work around for this problem i could use presets on the bcr but then i have 2 presets for one pattern one on the mc and one on the bcr. It should rly be easy if there is a way to set the default values of a pattern to the bcr.

I tried several different midi settings on the mc but the problem is that the mc doesnt send anything on switching pattern.

Some advice would be appreciated.

David
Post Reply